Plastic Nail-In Clips

Micro Plastics' molded Nail-In Clips are used to safely install cable T.V., fiber optic, computer network, telephone, and other communication, hydraulic, and pneumatic systems. The clips are molded in tough, electrically insulating, ultra violet resistant, high density Polyethylene. Main stress areas of the clip have reinforcing ribs designed into the part to strengthen and absorb the impact. The Nail-In Clips have all contact edges radiused to protect cable or tubing from damage.

Micro Plastics' clips are supplied with heat treated, galvanized steel nails pre-assembled, ready for use in masonry, wood, plaster, or stucco. Clips are easily and efficiently installed, resulting in a low in-place cost. Micro Plastics' Nail-In Clips are stocked in the most popular cable sizes ranging from 4mm to 9mm including the RG59 and the double shield cables.

Click here to order samples of any item on this page.

ITEM NUMBER A B C D E
22NCC0400R* .210 .375 .160 .160 .215
22NCC0500R* .250 .420 .200 .202 .285
22NCC0700R .285 .535 .263 .265 .340
22NCC0800R .300 .610 .314 .317 .400

ITEM NUMBER A B C D E
22NCC0450F* .205 .398 .105 .218 .175
22NCC0900F .420 .700 .215 3/8" .335
*These Sizes Are Not Suitable for Use in Masonry.
1,000 Piece Minimum Order Quantity


| Wire Handling Hardware |
| Micro Plastics Main Index | General Info |


Other ABE Approved ManufacturersUnitrack Design GuideThomas and Betts Design GuideSouthco Design GuideSanyo Denki Design GuideRecoil Hardware Design GuideRAF Electronic Hardware Design GuidePOP Design GuidePIC Designs Design GuidePanduit Design GuideMicro Plastics Design GuideManhattan/CDT Design GuideKeystone Electronics Design Guideigus Design GuideHeyco Products Design Guide Craftech Design GuideCaptive Fasteners Design GuideAvdel Cherry Textron Design GuideAccuride Design GuideABE Commercial ProductsSearch ABE's web site Manufacturer's Log InCustomer's Log In