Installation Procedure
1. Rivscrew is placed through the prepared hole in the  component and into the accepting material. 2. The high speed tool is activated and as the mandrel pulls through the Rivscrew expands forming into the surrounding material. 3. During installation, a domed head is formed on the Rivscrew achieving high clench and secure clamp-up.  The mandrel action also leaves a hexagonal bore in the Rivscrew facilitation easy removal with a standard key when required.  Another Rivscrew is automatically positioned for the next insertion.
Notes:
1. Unpodded and screened Rivscrew for use with Rivmatic (1712-3306, etc) are identical to podded Rivscrews (1712-3006, ect.)  Note:  3 added to 6th digit of podded Part Nos. to make unpodded & screened Part Nos.
2. To install Avdel Fasteners, use of Avdel specified installation tooling is recommended.
3. Avdel Fasteners are ready for use as supplied and shall not be reprocessed or degreased prior to installation as this may affect performance.
4. Part Nos. marked * are for advance information only.


Other ABE Approved ManufacturersUnitrack Design GuideThomas and Betts Design GuideSouthco Design GuideSanyo Denki Design GuideRecoil Hardware Design GuideRAF Electronic Hardware Design GuidePOP Design GuidePIC Designs Design GuidePanduit Design GuideMicro Plastics Design GuideManhattan/CDT Design GuideKeystone Electronics Design Guideigus Design GuideHeyco Products Design Guide Craftech Design GuideCaptive Fasteners Design GuideAvdel Cherry Textron Design GuideAccuride Design GuideABE Commercial ProductsSearch ABE's web site Manufacturer's Log InCustomer's Log In